Peripherals
"Shortening Grinding Processing Time on the Order of Microns with a New Method: Rotating Grinding Wheel Measuring Camera System"
➀ Purpose Due to the influence of the shape of the grinding wheel and the runout of the grinding wheel shaft in precise grinding processing, there was a problem that it was necessary to repeatedly check the shape of the grinding wheel by discarded research (dummy machining) and check the workpiece after grinding processing in […]
Automating coolant liquid replenishment and concentration management of machine tools! Zero daily process of adding processing fluid!!
(1) Purpose When machining with a long machining time, the coolant becomes insufficient, and an alarm is issued and the machine stops. The task of adding to the patch became laborious, and it was a state where people had to get it. (2) Points of introduction Introduced Iwamoto Kogyo's "Raku~Ranto". ・ By connecting pipes from […]
Measure 1/100th on the machine after processing on a turret lathe! Example of use of on-board measuring machine!!
(1) Purpose After machining the outer and inner diameters on a lathe, the dimensions are measured by measuring outside the machine. The number of 3D measuring machines is limited, and it is necessary to solve the stagnation of the process with an on-board measuring machine when stagnation to the next process occurs while waiting in […]
Reduce material loss rates! Introducing the effect of introducing an on-board measuring machine!
(1) Purpose After processing, when measurement is performed using an external measuring machine and additional work is required, it can not be returned to the original posture on the machine table and may be discarded. Using the on-board measuring machine "NK-2000", dimensions are checked on the processing machine, and it is introduced to solve the […]
Ultra-low pressure shot blasting technology reduces polish time by about 98%!
(1) Purpose In the product section of injection molding molds, it took a lot of time to process the machined surface (hand polishing) after cutting, discharging, and grinding processing. Low pressure shot blasting is used for process improvement with fine shapes and many polishing points, making it difficult to improve efficiency. (2) Points of introduction […]
MOLDINO Co., Ltd.
Introduction of SUS Multi Reduces Monthly Processing Costs by 60% Purpose Challenges We received a consultation about wanting to shorten the current 90 minutes machining time for processing SUS304. Points of introduction We have proposed EPSM for SUS special tools. Bibrating inhibition blade type unequal division shape, Smooth chip discharge with two-stage gash Double Exen […]