I want to increase productivity without introducing new equipment
"Shortening Grinding Processing Time on the Order of Microns with a New Method: Rotating Grinding Wheel Measuring Camera System"
➀ Purpose Due to the influence of the shape of the grinding wheel and the runout of the grinding wheel shaft in precise grinding processing, there was a problem that it was necessary to repeatedly check the shape of the grinding wheel by discarded research (dummy machining) and check the workpiece after grinding processing in […]
Measure 1/100th on the machine after processing on a turret lathe! Example of use of on-board measuring machine!!
(1) Purpose After machining the outer and inner diameters on a lathe, the dimensions are measured by measuring outside the machine. The number of 3D measuring machines is limited, and it is necessary to solve the stagnation of the process with an on-board measuring machine when stagnation to the next process occurs while waiting in […]
Reduce material loss rates! Introducing the effect of introducing an on-board measuring machine!
(1) Purpose After processing, when measurement is performed using an external measuring machine and additional work is required, it can not be returned to the original posture on the machine table and may be discarded. Using the on-board measuring machine "NK-2000", dimensions are checked on the processing machine, and it is introduced to solve the […]
Reduced machining time by 67%! Introducing a case study of high-efficiency processing using KC polar end mills!!
(1) Purpose In order to improve machining efficiency using the machining center we have, we utilize a new tool "KC Polar End Mill" based on new processing technology. (2) Points of introduction New three-bladed radius end mill based on low speed high feed processing technology Special 3D negative shape with 3 blades reduces vibrating and […]