➀ Purpose
Increased efficiency and cost reduction of mold-based roughing operations
(2) Points of introduction
The Φ16 high-feed cutter made by another company that had been used in the past was switched to the TD4N made by MOLDINO.
Shortened machining time by greatly increasing processing efficiency and cost reduction by improving the durability of inserts.
(3) Processing verification
Machining contents: Mold-based S55C coarse-processing
tool used: MOLDINO
body ... TD4N2016M-2&ASC16-8.5-160-95Z
Insert... ENMU0603ER-C-GX2140
Click here for product characteristics and detailed information (
lead to the MOLDINO manufacturer page)
(4) Processing results
* Z notch volume (ap): 0.5 mm→0.6 mm (1.2 times) * Table feeding: 2,000 mm/min→ 4,700 mm/min (2.35 times) and succeeded
in improving processing conditions and cut layer emissions: 10 cc/min→ 28.20 cc/min (2.8 times).
The life of the insert, which was limited to 2 hours with conventional high-feed cutters made by other companies, is normal wear even after 2 hours of use with MOLDINO. The reduction of inserts used also led to cost reductions.
